Atmoswiki

Huafast HS 3D-printer

Turn on printer using silver button on front of device
lower print table
- Select move option on touch screen
- Use the 10mm option
- Lower the table by at least 100mm
- Return to home screen
Select preheat option
- Use cleaning tool to remove excess plastic from print head. CAUTION HOT
- Turn off preheat as soon as excess plastic is removed
Remove magnetic pad from table
- May require bending or scraping to fully remove print residue
- Replace in printer when done
Remove filament scraps from bottom of printer
Turn off printer

Turn on printer using silver button on front of device
Open lid
Push button on top of printer head while pulling filament to remove filament from printer head
Feed excess filament through back of printer
Remove old roll from printer back, replace with new
Feed filament through filament detector and into body of printer
Feed filament into top of printer head pressing button while applying pressure
Preheat printer head
Manually push filament into printer head until printer head extrudes new filament
Check feed mechanism using button on home screen
Turn off preheat and printer

Remove filament from printer head
Turn off printer and allow to cool
Using supplied hex bolt, remove bolt on bottom of head
Pull out heating element and temp sensor
Using supplied hex bolt, remove bolt on right side of head between the guide rails
Pull old head off of the head assembly
Replace with new head and tighten side bolt at same time
Reinsert heater element and temp sensor
Using supplied hex bolt, tighten bolt on bottom of head
Turn on printer and preheat head
Reinsert filament into printer head pushing until extrusion
Turn off printer

Insert drive with sliced print project
Turn on printer using large silver button on front
Select Preheat button on touch screen
Return to start menu
Select leveling button on touch screen
- Using menu and knobs on underside of table, level table to .04ish mm or about the thickness of a piece of paper
Return to start menu
Select print button
Select desired print project
Monitor print for discrepancies
Turn off printer when done
Remove print from pad
Replace pad on print table

Ultimaker Cura
- Freely available online
- Easy to use
- preset settings for quick start