Differences

This shows you the differences between two versions of the page.

--- atmos:3dprinter:online3dprinternotebook [2018/10/28 09:00] – nloeb
+++ atmos:3dprinter:online3dprinternotebook [2020/01/29 17:25] (current) – external edit 127.0.0.1
@@ Line 2: / Line 2: @@
 **Latest information is given at the top.  Times and dates are local time.**
+/12/06 11:30 - Nick Gapp: Printed 4x anemometer driveshaft, 4x wind vane driveshaft, 4x anemometer/wind vane body, 4x anemometer/wind vane bearing housing, and 3x wind vane alignment tool.
+/12/05 18:38 - Nick Gapp: Printed wind vane parts--1x rotor, 1x body, 1x bearing housing, 1x driveshaft, 1x cover, 1x pointer, 1x pointer clamp bolt, 1x sensor holder disk, 1x base, 1x wind direction connector, 1x gripping tool.
+/12/05 11:10 - Nick Gapp: Printed anemometer parts--3x cup, 1x hub, 1x body, 1x bearing housing, 1x driveshaft, 1x sensor holder, 1x base, and 1x 3-pin anemometer connector.
+/11/29 19:40 - Shawn Wagner: Printed 4 tipping buckets.
+/11/28 20:31 - Shawn Wagner: Created and printed the updated raingauge rim for calibrated setup (87.29 mm).
+/11/02 15:45 - Nick Gapp: Printed for the rain gauge: 1x base, 1x cover with open sides ("cover inside inspection2"), and 3x counterbalance.
+/11/01 16:55 - Nick Gapp: Tried printing 1x bucket, 1x cover with open sides ("cover inside fit inspection2"), and 2x counterbalance.  AfiniaStudio apparently crashed about halfway through the print, so the only thing to finish printing was the bucket.
+/10/31 15:10 - Nick Gapp: Printed for rain gauge: 1x fixed funnel.
+/10/30 20:00 - Nick Gapp: Printed wiring: 8x small lock nut and 8x tapered cable cover.
 /10/27 22:00 - Shawn Wagner: Printing 4x 3 hole setting tool; 4x 4 hole setting tool; 1x 3 pos shunt; 4x 4 pos shunt; 3x 5 pos shunt .