atmos:citation:instruments:setup_young_anemometer:home
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
atmos:citation:instruments:setup_young_anemometer:home [2024/04/19 17:13] – benolson | atmos:citation:instruments:setup_young_anemometer:home [2024/04/19 17:20] (current) – benolson | ||
---|---|---|---|
Line 13: | Line 13: | ||
*While testing you will need to use the green serail board provided below. Follow the instructions in the manual to wire the ports to the number on the board. | *While testing you will need to use the green serail board provided below. Follow the instructions in the manual to wire the ports to the number on the board. | ||
*You will need to use a male to male connecter as the usb is serial type male and the green board is also type male. Their is a null modem in between during testing to ensure the correct rs232 read pin on the usb lines up with the write pin of the Anemometer. This will not be needed in the final configuration as you will be wiring up a female connector later but for testing it is needed. | *You will need to use a male to male connecter as the usb is serial type male and the green board is also type male. Their is a null modem in between during testing to ensure the correct rs232 read pin on the usb lines up with the write pin of the Anemometer. This will not be needed in the final configuration as you will be wiring up a female connector later but for testing it is needed. | ||
- | 3. Once its wired up you should be able to go to cutecom | + | 3. Once its wired up you should be able to go to cutecom |
- | *To find the device name go to | + | *https:// |
atmos/citation/instruments/setup_young_anemometer/home.txt · Last modified: 2024/04/19 17:20 by benolson