atmos:citation:instruments:setup_young_anemometer:home
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| atmos:citation:instruments:setup_young_anemometer:home [2024/04/19 17:15] – benolson | atmos:citation:instruments:setup_young_anemometer:home [2024/04/19 17:20] (current) – benolson | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| *While testing you will need to use the green serail board provided below. Follow the instructions in the manual to wire the ports to the number on the board. | *While testing you will need to use the green serail board provided below. Follow the instructions in the manual to wire the ports to the number on the board. | ||
| *You will need to use a male to male connecter as the usb is serial type male and the green board is also type male. Their is a null modem in between during testing to ensure the correct rs232 read pin on the usb lines up with the write pin of the Anemometer. This will not be needed in the final configuration as you will be wiring up a female connector later but for testing it is needed. | *You will need to use a male to male connecter as the usb is serial type male and the green board is also type male. Their is a null modem in between during testing to ensure the correct rs232 read pin on the usb lines up with the write pin of the Anemometer. This will not be needed in the final configuration as you will be wiring up a female connector later but for testing it is needed. | ||
| - | 3. Once its wired up you should be able to go to cutecom and follow the below video to setup the custom format to include all of the 2d and 3d data. | + | 3. Once its wired up you should be able to go to cutecom and follow the below link to an unlisted youtube |
| - | {{ : | + | |
atmos/citation/instruments/setup_young_anemometer/home.txt · Last modified: 2024/04/19 17:20 by benolson