This is an old revision of the document!
Intial Raspberry Pi setup instructions
1.Change the hostname to TIMMS-SN00XXX etc/hostname “TIMMS-SN00XXX” Example for TIMMS with a serial number SN00200 in the command line use “sudo vi etc/hostname TIMMS-SN00200” without parentheses
2. Change etc/host ex. use the command “sudo vi etc/hosts” then from here set 127.0.1.1 to TIMMS-SN00XXX with the serial number of the tripod
3. Update the base raspberry pi software using the command “sudo apt update” to check available updates then “sudo apt upgrade” to perform the updates.
4.Setup Anydesk security to unatteded access
5.Set Password to standard password
After these steps are done move onto setting up the camera depending on which type of camera is being used back on the main tripod page