atmos:northpolradar:radar_needs
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
atmos:northpolradar:radar_needs [2010/05/25 17:34] – ctheisen | atmos:northpolradar:radar_needs [2020/01/29 17:25] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Radar Needs ===== | ||
+ | (Current: last updated March 2014) | ||
+ | * Fix radome hatch weather seal. | ||
+ | * Better solution to prevent water from dripping on the AMR in radome (instead of the blue tarp). | ||
+ | * New Plywood sheet for hole on floor in radome. | ||
+ | * New receiver so we can upgrade software to work on RHEL6. | ||
+ | * Replace magnetron/ | ||
+ | * Fix safety switch in radome...loose connection. | ||
+ | * Clean slip rings and lubricate gears (every spring). | ||
+ | * Install dehumidifier in radome every spring and remove every fall. | ||
+ | * Maintenance on waveguide compressor (dry desiccant, check for leaks, etc.) every spring. | ||
+ | * Check UPS batteries every month. | ||
+ | * Determine solution to local frequency interferences. | ||
+ | |||
+ | |||
+ | | ||
+ | (Pre-October 2011) | ||
+ | * Reseal radome with silicone on inside, have the radome professionally sealed and painted on outside, or replace entire radome with new. | ||
+ | * Fix wedges to help seal radome hatch. | ||
+ | * Better solution to prevent water from dripping on the AMR in radome. | ||
+ | * New Plywood sheet for hole on floor in radome. | ||
+ | * New RVP8 computer (motherboard) and configuration (1 rx board w/ 1 IFD). | ||
+ | * Fix safety switch in radome...loose connection. | ||
+ | * Clean slip rings and lubricate gears (every spring). | ||
+ | * Install dehumidifier in radome every spring and remove every fall. | ||
+ | * Replace magnetron/ | ||
+ | * Rebuild components of the servo amp. | ||
+ | |||