Differences

This shows you the differences between two versions of the page.

--- atmos:citation:instruments:raspberrypi_setup:home [2024/03/18 19:04] – benolson
+++ atmos:citation:instruments:raspberrypi_setup:home [2024/03/22 19:41] (current) – benolson
@@ Line 1: / Line 1: @@
 ===Intial Raspberry Pi setup instructions===
 .Change the hostname to TIMMS-SN00XXX
- etc/hostname "TIMMS-SN00XXX" Example for TIMMS with a serial number SN00200 in the command line use "sudo vi etc/hostname TIMMS-SN00200" without parentheses
+ etc/hostname "TIMMS-SN00XXX" Example for TIMMS with a serial number SN00200 in the command line use "sudo vi etc/hostname TIMMS-SN00200" without parentheses as typed below
+sudo vi etc/hostname TIMMS-SN00200
 . Change etc/host
 ex.  use the command "sudo vi etc/hosts" then from here set 127.0.1.1 to TIMMS-SN00XXX with the serial number of the tripod
-. Update the base raspberry pi software using the command "sudo apt update" to check available updates then "sudo apt upgrade" to perform the updates.
+sudo vi etc/hosts
+{{:atmos:citation:instruments:raspberrypi_setup:screenshot_2024-03-22_142815.png?400|}}
+. Update the base raspberry pi software using the command "sudo apt-get update" to check available updates then "sudo apt upgrade" to perform the updates.
+sudo apt-get update
+. Intall anydesk via the link https://anydesk.com/en/downloads/linux
-.Setup Anydesk security to unatteded access
+.Set Password to standard password (if you don't know the standard password ask Dr. Delene)
-.Set Password to standard password
+. Placeholder for adding the sourceforge ADPAA repository to the raspberry pi
 After these steps are done move onto setting up the camera depending on which type of camera is being used back on the main tripod page