Differences

This shows you the differences between two versions of the page.

--- atmos:citation:instruments:raspberrypi_setup:home [2024/03/18 19:01] – benolson
+++ atmos:citation:instruments:raspberrypi_setup:home [2024/03/22 19:41] (current) – benolson
@@ Line 1: / Line 1: @@
 ===Intial Raspberry Pi setup instructions===
 .Change the hostname to TIMMS-SN00XXX
- etc/hostname "TIMMS-SN00XXX" Example for TIMMS with a serial number SN00200 in the command line use "sudo vi etc/hostname TIMMS-SN00200" without parentheses
+ etc/hostname "TIMMS-SN00XXX" Example for TIMMS with a serial number SN00200 in the command line use "sudo vi etc/hostname TIMMS-SN00200" without parentheses as typed below
+sudo vi etc/hostname TIMMS-SN00200
 . Change etc/host
 ex.  use the command "sudo vi etc/hosts" then from here set 127.0.1.1 to TIMMS-SN00XXX with the serial number of the tripod
-. Update the base raspberry pi software using the command "sudo apt update" to check available updates then "sudo apt upgrade" to perform the updates.
+sudo vi etc/hosts
+{{:atmos:citation:instruments:raspberrypi_setup:screenshot_2024-03-22_142815.png?400|}}
+. Update the base raspberry pi software using the command "sudo apt-get update" to check available updates then "sudo apt upgrade" to perform the updates.
+sudo apt-get update
+. Intall anydesk via the link https://anydesk.com/en/downloads/linux
+.Set Password to standard password (if you don't know the standard password ask Dr. Delene)
-.Setup Anydesk security to unatteded access
+. Placeholder for adding the sourceforge ADPAA repository to the raspberry pi
-.Set Password to standard password
+After these steps are done move onto setting up the camera depending on which type of camera is being used back on the main tripod page