atmos:citation:instruments:raspberrypi_setup:home
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
atmos:citation:instruments:raspberrypi_setup:home [2024/03/18 19:01] – benolson | atmos:citation:instruments:raspberrypi_setup:home [2024/03/22 19:41] (current) – benolson | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===Intial Raspberry Pi setup instructions=== | ||
1.Change the hostname to TIMMS-SN00XXX | 1.Change the hostname to TIMMS-SN00XXX | ||
- | | + | |
+ | |||
+ | sudo vi etc/ | ||
2. Change etc/host | 2. Change etc/host | ||
ex. use the command "sudo vi etc/ | ex. use the command "sudo vi etc/ | ||
- | 3. Update the base raspberry pi software using the command "sudo apt update" | + | sudo vi etc/hosts |
+ | |||
+ | {{: | ||
+ | |||
+ | 3. Update the base raspberry pi software using the command "sudo apt-get update" | ||
+ | |||
+ | sudo apt-get update | ||
+ | |||
+ | 4. Intall anydesk via the link https:// | ||
+ | |||
+ | 5.Set Password to standard password (if you don't know the standard password ask Dr. Delene) | ||
- | 4.Setup Anydesk security | + | 6. Placeholder for adding the sourceforge ADPAA repository |
- | 5.Set Password to standard password | + | After these steps are done move onto setting up the camera depending on which type of camera is being used back on the main tripod page |
atmos/citation/instruments/raspberrypi_setup/home.1710788474.txt.gz · Last modified: 2024/03/18 19:01 by benolson